Axis / Spacer sets the insertion axis (path of draw) and the cement spacer of the crowns. It opens over the view with the prepared arch and its margins drawn in red. You may skip it: Design always applies the cement spacer, from your last applied values or the defaults 0.08 / 0.5 / 0.3 mm.

  1. Confirm the margins first, then click Axis / Spacer in the step bar.
  2. Look at the preparation: blue on the stump is undercut along this axis. The proposed axis normally shows none.
  3. If needed, drag the blue arrow tip or use the sliders. Check the spacer values.
  4. Click ✓ Confirm & Apply, then Design.

1. Insertion axis

The blue arrow starts 12 mm above the preparation and points in the removal / viewing direction; the crown goes on the opposite way. The axis is proposed from the preparation: the direction that leaves no blue undercut on the stump, keeps draw on every wall and exposes both neighbours equally. With two or more crowns each tooth has its own axis: pick its number and the view turns around it. A bridge gets one common path of draw for all abutments.

  • Front / BackTilts the axis forward or back, −180° to 180°; 0° is the proposal.
  • Left / RightTilts the axis to either side, −90° to 90°.

2. Cement spacer

  • Cement ThicknessThe gap between the inside of the crown and the die. Default 0.08 mm (0 to 0.5).
  • Cement Starting PointHow high above the margin the gap begins; below it the crown fits the die closely. Default 0.5 mm (0 to 5).
  • Margin WidthThe band just inside the margin that keeps no gap, so the margin seals. Default 0.3 mm (0 to 2).
  • Minimum ThicknessOcclusal minimum for anterior (canine to canine, 0.5 mm) and posterior teeth (1.0 mm), and for axial walls (0.6 mm). Shown in purple on the crown with Show Thin Areas at Occlusal / Axial Walls; the crown is never thickened to meet it.
  • Margin thicknessThe crown's wall 0.3 to 0.7 mm above the margin, measured straight in to the prepared tooth. Default 0.2 mm (0 to 1). Shown in purple with Show Thin Areas at Margins; the crown is never changed.

3. Undercut display

  • Show undercuts relative to current axisPaints undercut surfaces blue for the current arrow. On by default.
  • Sensitivity0 to 1, default 0.50. Higher shows smaller undercuts as blue.
  • Reset AllBack to the proposed axis and the default spacer and thickness values.
  • ✓ Confirm & ApplySaves the axis and spacer for this case; Design uses them. If a design already exists and you changed something, it is kept as an earlier version and the next Design builds a new one. Viewing without changes recalculates nothing.

A margin that is not confirmed opens Axis / Spacer with the note to confirm it first. For an arch prescription (night guard), Axis / Spacer opens the Nightguard's own Path of draw step instead.