Edit Models

Match Models

Opens Model Match, where each scan gets its role: upper or lower jaw, prepared or pre-op, bite. Design and the contacts follow these roles, so check them whenever a case is new or a scan is replaced.

A common Model Match error: after margins are drawn for an onlay preparation on a second molar and the path of draw is set, Design reports that the margin is on the opposing scan and must be reassigned to the prepared scan. The dentist shows the fix: go to Model, Edit Models, Match Models, see that the model holding the margin was labeled wrongly, set it to Maxilla Working, confirm and continue with the design. He notes this naming slip happens often when rushing.

Align Models

Lines up scans that do not sit together, for example a bite scan with the upper and lower jaws. Mark one model Fixed and the others Moving, then press Auto align, or pick matching points on both and press Align points. Refine tightens the fit. The whole alignment is one Undo.

Compare Models

Colours the two visible models by their distance from each other, to show where a scan, a wax-up or a design differs. Point at the surface to read the distance; the scale and its histogram sit in the bottom-right corner. Show the two models to compare. Press it again to turn it off.

Measure

Measures on the visible models. Click a first point, then a second: the line and its length appear. The two points can be on different models. Right-click or Undo takes back the last point or measurement; Esc drops one you started. Nothing on the models changes.

Surface Segmentation

Copies part of a surface into a model of its own. Choose Paint (a brush, Radius 0.3 to 5 mm), Polyline (click around the area, then click the first point to close it) or Erase, then press Create selected surface. The copy goes to Results; the scan stays as it was.

Shows Surface Segmentation in Edit Models: circumscribe or paint an area, or outline it with Polyline, and create a new STL model of just that part, which can then be moved, enlarged, rotated, flipped or mirrored like any other model. As an example the dentist segments out a canine and explains that a crown taken this way can be placed over a tooth with a margin to serve as the pre-op for a replication case.

Color Analysis

On colour scans, paints each tooth surface with its nearest VITA shade and shows a shade map: a shade wheel and the share of each shade, with the preparations left out. The button under it sets the restoration colour to the top shade. A guide only: scanner colours are not calibrated.

Flip Normals

Turns the visible models inside out, for a scan whose inside faces outward. Each flipped copy goes to Results under its own name, and the original is hidden. Undo takes it back.

Path of Draw

Builds a blockout of the model along a path of insertion, filling the undercuts in that direction. Start from Use proposed path (taken from the model's margins) or Use current view, adjust it with Reverse direction and the Front / back and Left / right sliders, choose the Surface resolution (0.10, 0.15 or 0.25 mm) and press Confirm. The blockout draft goes to Results.

Bridge

Closes a big hole, such as a round access opening. Click inside the hole on the model: it is closed with a smooth surface that follows the shape around it. Click the next hole to close it too; each one has its own Undo. For small holes, use Fill Hole.