Import sits in the bottom bar of Model Work, next to Combine / Boolean, once a case is open and you are signed in. It adds files to the open case and never replaces it. Click it and its cards fan up; Escape or a click outside closes them. Import waits while another import runs, while a design is calculating or while Combine / Boolean is calculating.
Master teeth
Any tooth 11-48 from the master set. Click its number: the tooth is added to this case and lines up on its margin and path of draw by itself. Fine-tune it in Transform.
In the Import Library
After the import
- A single part is placed at the selected tooth or the centre of the view, and Align Models opens with the part as Target: 3 points on the part, 3 on the scan, fine-tune, then Pin in place.
- New scans (not margins or parts) open Model Match, unless you have chosen to skip it, so that each scan gets its role: upper or lower jaw, prepared or pre-op, bite.
- Imported parts stay separate models: combine a part with a model yourself in Combine / Boolean.
Other ways to bring in models
New Case in the left column takes the same files. With models already open it asks first: Start New Case saves the current case before opening the selected files; Add Files to This Case keeps your current models, patient information and design work. Import Scanner connects Medit Link and other scanners: with Export + Watch Folder, the models you export load here by themselves.