Mill shows how a bur of your chosen tip reaches the inside of each crown, compares three ways to prepare the inside, and builds the files for your CAM. Nothing is charged on this page.

  • Without compensationLeave it for my CAM: the inside as designed. Red shows where the tip would press on the preparation; green, the relief your CAM must add.
  • With compensationThe relief for your tip is built into the inside, so the tip clears the preparation. It shows the thinnest crown left; under 0.4 mm it suggests a smaller tip.
  • Least material removedRelief only where the tip would press on the preparation, with the spacer tightened elsewhere (never more than your cement gap), so the least block material is milled. It seats just as well.
  • Tip diameterYour bur's tip, 0.3 to 2.5 mm (slider or typed). Every view and set is worked out again for the new tip.
  • TurnShows the cross-section at 90°.
  • AllA table of every restoration: block material milled per option, and what the least-material inside saves. Next › moves to the next tooth.
  • Continue to purchase and downloadShows the price for every crown, asks for the design approval, then opens the milling review: enter the Material (Shade is optional), tick I have reviewed the case images and cross-sections., and pay. Downloads unlock after a verified payment.

Mill sets

  • Standard STL Output$1.50 for the first crown. Always included. No edits to the inside, no construction file or margin line: the margins are redrawn in your own CAM.
  • Without compensation + construction file + STL$1.50 for the first crown. Margin line and construction file for your CAM, without bur compensation (folder without-compensation).
  • With compensation + construction file + STL$1.50 for the first crown. Inside compensated for your tip, with margin line and construction file (folder with-compensation-<tip>mm).
  • Least material removed$3.00 for the first crown. Our own inside that removes the least material, with its spacer change recorded as the cement gap (folder best-fit-<tip>mm). Only available here.

Each set is one folder: the STL file(s) and a construction file naming them. Each crown after the first is 10% less. Test the construction file with your CAM on a non-patient case first.