An overview of the ways to design a restoration. Copy mode gives an exact copy of the pre-op tooth (the dentist notes that holes are filled, and that a more complete scan means less work and faster results); AI mode reads the whole arch, the contacts of the adjacent teeth, how the cusp tips line up in the arch form, and the height of contour. A master tooth from the library can also be imported, positioned in the arch and snapped to the margins, which he suggests for multiple units, long distal extensions and edentulous ridges, followed by Copy mode from that tooth. The fourth way is mirroring the contralateral tooth from a full-arch scan.

There are four ways to design a restoration. The two main ones are Copy, an exact copy of the pre-op (the software fills any holes in the scan; the better the scan, the less work), and AI, which reads the whole arch, the contacts of the adjacent teeth, the line of the cusp tips and the height of contour, and takes a little longer. You can also design by hand: import a master tooth from the library, position it and let the software snap it to the margins; this suits multiple units, distal extensions and edentulous ridges, and you can then Copy off it. The fourth way is Mirror: an exact mirror of the tooth on the contralateral side.

Design builds the restorations the prescription asks for, from the prepared scan, its margins and the Axis / Spacer settings (or their defaults). Each new crown appears in Results, named by how it was built and its tooth number (for example AI-37).

  1. Click Design in the step bar.
  2. If a card asks how to build the tooth, choose (see below).
  3. Wait for the progress card. The crown appears in Results; the scans stay as they were.
  4. Check the contacts, refine with Design Tools, then go on to Manufacture.

Copy or AI proposal

With a pre-op or wax-up scan (a Non-Working scan on the working jaw) and one or two units, a card asks how to build each tooth. With no pre-op, the AI proposal starts at once; with a pre-op and three or more units, or with pontics, the copy starts at once.

  • Copy the pre-opThe crown is the patient's own tooth from the pre-op or wax-up, carved down to the margin with the cement spacer inside. See Copy.
  • AI proposalThe AI builds the crown from the preparation and its margin. Every AI crown needs your review. See AI proposal.
  • Mirror 21 · Master 11Front teeth with no pre-op: Mirror copies the intact tooth on the other side of the midline, flipped (its incisal edge included). A tooth whose partner is prepared too, or not surely found, takes the master tooth instead. Posterior teeth are not mirrored.

Both builds

After one build, clicking Design again offers the other one for the same one or two teeth. The second result is added to Results; the first is never replaced.

  • Add the AI proposalBuilds the AI proposal too; the copy stays in Results.
  • Keep only the copyCloses the card and opens the copy you have.
  • Add the copyBuilds the copy of the pre-op too; the AI proposal stays in Results.
  • Keep only the AI proposalCloses the card; nothing else is built.

Tooth number check

  • Use 46When the Rx says one tooth (for example 36) but the scan looks like another (46), a card asks. Use 46 renumbers the margin (Undo puts it back) and Design goes on.
  • Keep 36Keeps the Rx number and goes on; you are not asked again for that margin.

Moving between the steps without changing anything never recalculates: Design reopens the result at once. Only a real change (a margin, a scan, the axis or spacer) builds again. Purple stretches of an automatic margin are unconfirmed; Design uses them as they are.

Crowns built joined (several connected units) are offered the Split Them card afterwards; it can be reopened from Split Them in Edit Tools.