- Draw newDraw new: double-click the preparation to start, click around it, then double-click to close the loop. Right-click removes the last point; right-drag rotates.
- Redraw sectionRedraw section: double-click on the green line to start, click along the new path, then double-click back on the line to finish.
- Move nodesMove nodes: drag a white node along its preparation. Double-click the line between nodes to add one.
- Close loopClose the loop (Draw new) or join the new path back onto the line (Redraw section).
- Clear draftRemove the points placed so far.
- Reset importedPut imported margins back as they came in.
Draw new
Draw new: double-click the preparation to start, click around it, then double-click to close the loop. Right-click removes the last point; right-drag rotates.
Shows how to open the Margins step from the navigation bar and either import a margin marked in other software and edit it, or click Mark New Margin. You start with a double-click, single-click to tack the line down around curves, and double-click or Close loop to finish. The dentist stresses one even line in one direction without sharp bends or ledges, and explains that while the AI tries to find the margin, monochromatic scans make the tooth-gingiva border hard to see, so users should be comfortable redrawing sections and moving nodes. The margin then sets the axis, or path of draw.
Open Margins from the step bar; the Margin Pencil opens in the top-left corner. A margin marked in other software comes in with your scans and can be edited here. To mark a new one, press Draw new: double-click on the margin to start, single-click to tack the line down through turns and curves, and double-click to finish, or press Close loop. Keep one smooth line running in one direction, with no sharp bends or ledges. The AI proposes margins, but on single-colour scans the gum and the tooth are hard to tell apart, so check every margin yourself: fix a stretch with Redraw section, or drag its points with Move nodes. When the line is right, go on to Axis or Design. Leaving Margins confirms them. The path of insertion in the next step follows from your margin.