The AI proposal is built in a fixed order: the margin and path of draw, the arch and side, the contacts with the neighbouring teeth, their cusp tips, then a master tooth fitted to all of these. The master is moved, turned and scaled evenly; only the ridges along its edges are reshaped. The result reads AI proposal, review required: check it before you manufacture.

When the AI cannot place the crown

  1. Results shows the master tooth, raw, as "AI tooth NN · position it", with Move already open on it.
  2. Move and rotate it roughly into place over the preparation.
  3. Press Confirm: the AI fits it to the margin from your position and carves the crown as usual. Undo puts it back.

Guide lines in Results

  • Cusp tip guidelinesThe yellow lines through the neighbours' cusp tips that the AI placed its crown on. The eye hides or shows them, the slider sets their opacity (0-100 %). Shown at 100 % by default; your choice is kept in this browser. The row appears only while those lines are in the case.
  • Contour guidelinesThe height-of-contour guide lines, with the same eye and opacity slider. The row appears only while such lines are drawn in the case.

No margins yet

  • Mark my own marginsOpens Margins to draw them yourself.
  • Automatic AI proposalNo margins needed: the pre-op is carved over the preparations, each prepared tooth's margin is found from that, and every tooth gets its own crown with its margin. Needs a pre-op scan of this jaw; review the margins afterwards.